[4/5] mtd: nand: samsung: Retrieve ECC requirements from extended
diff mbox series

Message ID 20220728171744.1761739-5-michael@amarulasolutions.com
State New
Headers show
Series
  • Another smaller update to the nand stack
Related show

Commit Message

Michael Nazzareno Trimarchi July 28, 2022, 5:17 p.m. UTC 
Upstream linux commit 8fc82d456e40a0.

On some nand controllers with hw-ecc the controller code wants to know
the ecc strength and size and having these as 0, 0 is not accepted.

Specifying these in devicetree is possible but undesirable as the nand
may be different in different production runs of the same board, so it
is better to get this info from the nand id where possible.

This commit adds code to read the ecc strength and size from the nand
for Samsung extended-id nands. This code is based on the info for the 5th
id byte in the datasheets for the following Samsung nands: K9GAG08U0E,
K9GAG08U0F, K9GAG08X0D, K9GBG08U0A, K9GBG08U0B. These all use these bits
in the exact same way.

Signed-off-by: Michael Trimarchi <michael@amarulasolutions.com>
---
 drivers/mtd/nand/raw/nand_samsung.c | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

Patch
diff mbox series 

diff --git a/drivers/mtd/nand/raw/nand_samsung.c b/drivers/mtd/nand/raw/nand_samsung.c
index 0ab8062193..36ef48e5ec 100644
--- a/drivers/mtd/nand/raw/nand_samsung.c
+++ b/drivers/mtd/nand/raw/nand_samsung.c
@@ -64,6 +64,26 @@  static void samsung_nand_decode_id(struct nand_chip *chip)
 		extid >>= 2;
 		mtd->erasesize = (128 * 1024) <<
 				 (((extid >> 1) & 0x04) | (extid & 0x03));
+
+		/* Extract ECC requirements from 5th id byte*/
+		extid = (chip->id.data[4] >> 4) & 0x07;
+		if (extid < 5) {
+			chip->ecc_step_ds = 512;
+			chip->ecc_strength_ds = 1 << extid;
+		} else {
+			chip->ecc_step_ds = 1024;
+			switch (extid) {
+			case 5:
+				chip->ecc_strength_ds = 24;
+				break;
+			case 6:
+				chip->ecc_strength_ds = 40;
+				break;
+			case 7:
+				chip->ecc_strength_ds = 60;
+				break;
+			}
+		}
 	} else {
 		nand_decode_ext_id(chip);
 	}