[v4,2/3] arm64: dts: allwinner: a64-amarula-relic: Add GT5663 CTP node

Message ID 20190418174720.17230-2-jagan@amarulasolutions.com
State New
Headers show
Series
  • [v4,1/3] arm64: dts: allwinner: a64: Move I2C pinctrl to dtsi
Related show

Commit Message

Jagan Teki April 18, 2019, 5:47 p.m. UTC
Add Goodix GT5663 capacitive touch controller node on
Amarula A64-Relic board.

The CTP connected to board with,
- SDA, SCK from i2c1
- GPIO-LD0 as AVDD28 supply
- PH4 gpio as interrupt pin
- PH8 gpio as reset pin
- X axis is inverted
- Y axis is inverted

Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
---
Changes for v4:
- drop i2c1 pinctrl
Changes for v3:
- Use 2.8v for reg_ldo_io0
Changes for v2:
- drop i2c1, bias-pull-up

 .../allwinner/sun50i-a64-amarula-relic.dts    | 23 +++++++++++++++++++
 1 file changed, 23 insertions(+)

Patch

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts b/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts
index c41131c03231..5634245d11db 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-amarula-relic.dts
@@ -97,6 +97,22 @@ 
 	bias-pull-up;
 };
 
+&i2c1 {
+	status = "okay";
+
+	touchscreen@5d {
+		compatible = "goodix,gt5663";
+		reg = <0x5d>;
+		AVDD28-supply = <&reg_ldo_io0>;			/* VCC-CTP: GPIO0-LDO */
+		interrupt-parent = <&pio>;
+		interrupts = <7 4 IRQ_TYPE_EDGE_FALLING>;
+		irq-gpios = <&pio 7 4 GPIO_ACTIVE_HIGH>;	/* CTP-INT: PH4 */
+		reset-gpios = <&pio 7 8 GPIO_ACTIVE_HIGH>;	/* CTP-RST: PH8 */
+		touchscreen-inverted-x;
+		touchscreen-inverted-y;
+	};
+};
+
 &mmc1 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&mmc1_pins>;
@@ -260,6 +276,13 @@ 
 	regulator-name = "vdd-cpus";
 };
 
+&reg_ldo_io0 {
+	regulator-min-microvolt = <2800000>;
+	regulator-max-microvolt = <2800000>;
+	regulator-name = "vcc-ctp";
+	status = "okay";
+};
+
 &reg_rtc_ldo {
 	regulator-name = "vcc-rtc";
 };