@@ -27,6 +27,7 @@
#include <linux/delay.h>
#include <linux/irq.h>
#include <linux/interrupt.h>
+#include <linux/regulator/consumer.h>
#include <linux/slab.h>
#include <linux/acpi.h>
#include <linux/of.h>
@@ -47,6 +48,7 @@ struct goodix_ts_data {
struct touchscreen_properties prop;
unsigned int max_touch_num;
unsigned int int_trigger_type;
+ struct regulator *avdd28;
struct gpio_desc *gpiod_int;
struct gpio_desc *gpiod_rst;
u16 id;
@@ -786,25 +788,41 @@ static int goodix_ts_probe(struct i2c_client *client,
if (error)
return error;
+ ts->avdd28 = devm_regulator_get(&client->dev, "AVDD28");
+ if (IS_ERR(ts->avdd28)) {
+ error = PTR_ERR(ts->avdd28);
+ if (error != -EPROBE_DEFER)
+ dev_err(&client->dev,
+ "Failed to get AVDD28 regulator: %d\n", error);
+ return error;
+ }
+
+ /* power the controller */
+ error = regulator_enable(ts->avdd28);
+ if (error) {
+ dev_err(&client->dev, "Controller fail to enable AVDD28\n");
+ return error;
+ }
+
if (ts->gpiod_int && ts->gpiod_rst) {
/* reset the controller */
error = goodix_reset(ts);
if (error) {
dev_err(&client->dev, "Controller reset failed.\n");
- return error;
+ goto error;
}
}
error = goodix_i2c_test(client);
if (error) {
dev_err(&client->dev, "I2C communication failure: %d\n", error);
- return error;
+ goto error;
}
error = goodix_read_version(ts);
if (error) {
dev_err(&client->dev, "Read version failed.\n");
- return error;
+ goto error;
}
ts->chip = goodix_get_chip_data(ts->id);
@@ -823,23 +841,28 @@ static int goodix_ts_probe(struct i2c_client *client,
dev_err(&client->dev,
"Failed to invoke firmware loader: %d\n",
error);
- return error;
+ goto error;
}
return 0;
} else {
error = goodix_configure_dev(ts);
if (error)
- return error;
+ goto error;
}
return 0;
+
+error:
+ regulator_disable(ts->avdd28);
+ return error;
}
static int goodix_ts_remove(struct i2c_client *client)
{
struct goodix_ts_data *ts = i2c_get_clientdata(client);
+ regulator_disable(ts->avdd28);
if (ts->gpiod_int && ts->gpiod_rst)
wait_for_completion(&ts->firmware_loading_complete);
Goodix CTP controllers have AVDD28 pin connected to voltage regulator which may not be turned on by default, like for GT5663. Add support for such ctp used boards by adding voltage regulator handling code to goodix ctp driver. Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> --- drivers/input/touchscreen/goodix.c | 33 +++++++++++++++++++++++++----- 1 file changed, 28 insertions(+), 5 deletions(-)