@@ -188,8 +188,12 @@ enum forced_boot_mode {
/* TAMP registers x = 0 to 127 : hardcoded description, waiting NVMEM node in DT */
#define TAMP_BACKUP_REGISTER(x) (STM32_TAMP_BASE + 0x100 + 4 * (x))
+#define TAMP_FWU_BOOT_INFO_REG TAMP_BACKUP_REGISTER(48)
/* TAMP registers zone 3 RIF 1 (RW) at 96*/
#define TAMP_BOOT_CONTEXT TAMP_BACKUP_REGISTER(96)
+
+#define TAMP_FWU_BOOT_IDX_MASK GENMASK(3, 0)
+#define TAMP_FWU_BOOT_IDX_OFFSET 0
#endif /* defined(CONFIG_STM32MP23X) || defined(CONFIG_STM32MP25X) */
/* offset used for BSEC driver: misc_read and misc_write */
@@ -224,3 +224,24 @@ void board_quiesce_devices(void)
{
setup_led(LEDST_OFF);
}
+
+#if defined(CONFIG_FWU_MULTI_BANK_UPDATE)
+
+#include <fwu.h>
+
+/**
+ * fwu_plat_get_bootidx() - Get the value of the boot index
+ * @boot_idx: Boot index value
+ *
+ * Get the value of the bank(partition) from which the platform
+ * has booted. This value is passed to U-Boot from the earlier
+ * stage bootloader which loads and boots all the relevant
+ * firmware images
+ *
+ */
+void fwu_plat_get_bootidx(uint *boot_idx)
+{
+ *boot_idx = (readl(TAMP_FWU_BOOT_INFO_REG) >>
+ TAMP_FWU_BOOT_IDX_OFFSET) & TAMP_FWU_BOOT_IDX_MASK;
+}
+#endif /* CONFIG_FWU_MULTI_BANK_UPDATE */
Following the commit 95b5a7de30f6 (“FWU: STM32MP1: Add support to read boot index from backup register”), this patch enables reading the boot index from backup registers on STM32MP2 platforms. Signed-off-by: Dario Binacchi <dario.binacchi@amarulasolutions.com> --- arch/arm/mach-stm32mp/include/mach/stm32.h | 4 ++++ board/st/stm32mp2/stm32mp2.c | 21 +++++++++++++++++++++ 2 files changed, 25 insertions(+)